![]() USB 2.0 full speed compatible interface. ![]() It also withstands voltages of up to 1000 V rms. In addition, to provide the same functionalities as the ST-LINK/V2, the ST-LINK/V2-ISOL features digital isolation between the PC and the target application board. STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments. ![]() Then later it is set to other small devices including STM8 series (Fig. Application opens up and you can read/write microcontroller. 14.9): UART file is kept mandatory for the link between ST-LINK/V2 and. ![]() STM8 applications use the USB full speed interface to communicate with ST Visual Develop (STVD) or ST Visual Program (STVP) software. So, first download STVP-STM8 from: ST Website - STVP-STM8 Then install it and start St Visual Programmer Select your programmer, in my case ST-Link, then mode (SWIMM) and your microcontroller. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board. ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. This is ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |